on 22.03.2015 at 17:15hrs Y phase 66kV class Power Trf-2 Current transformer has flashed over and oil came out. The failed CT has been replaced on 24.03.2015 at 13:15hrs and the Trf has been charged in presence of RT Hassan after conducting the pre-commissioning tests. On the same day at 17:00hrs the commissioned CT has again flashed over and immediately the Trf  has been isolated from power supply. It is confirmed the secondary is not opened and checked the earth integrity and is found ok. Here what would be the reason for the CT failure? 

2 Answers  

---

transformer losses

1 Answers  

---

what is different the DOL Starter and Star Delta STARTER

12 Answers   Schwing Stetter,

---

why we use low kv lightining arrester in line for example 9 kv using in 11kv

1 Answers  

---

what percent do you derate your copper wire when you change from copper buss to copper wire

0 Answers   Gerdau,

---

i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test

0 Answers  

---

What must the distance between two MV cables be when they are laid on tray?

0 Answers  

---

What is lc oscillator?

0 Answers  

---

What type of changeover switch needed to run a load of five 1.5 tonn ACs.

1 Answers  

---

calculate multiplication factor of a trivector meter with line ct ratio 200/5A, line PT ratio 11000/110V and meter CT ratio 200/1A and meter pt Ratio 11000/110V.

4 Answers  

---

PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com

0 Answers   RRB,

---

being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give

0 Answers  

---