what is the safe meggar values for motor, transformer HT, LT
and Cables?

IF we want to replace I/C bay at our 220 kv substation which
is of 140 mw load capacity bay to be replaced by 400 mw
capacity bay.other than CT(1200/1) what are the other
equipment i have to replace.

why we generally use 3.5 core cable or in other word 1/2
core for neutral and also confirm me that in balance
conditiob(3 phase)current in neutral will zero


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

star delta starter contorl circuit... drawing..

0 Answers  


what should we do when the CT secodary gets open? how do we short circuit it? using tester or screw driver? not dangerous?

6 Answers  


How many battery required for an 3kva online ups with 3 hrs back up with usage of 3 fans,3tube lights

1 Answers  


why nearly all the voltage levels are in the multiples of 11 like 3.3 ,6.6 ,33 ,11 kv.....

8 Answers   Suzlon,


Why diesel tank kept in 990 ltrs

1 Answers   Reliance,






on 22.03.2015 at 17:15hrs Y phase 66kV class Power Trf-2 Current transformer has flashed over and oil came out. The failed CT has been replaced on 24.03.2015 at 13:15hrs and the Trf has been charged in presence of RT Hassan after conducting the pre-commissioning tests. On the same day at 17:00hrs the commissioned CT has again flashed over and immediately the Trf  has been isolated from power supply. It is confirmed the secondary is not opened and checked the earth integrity and is found ok. Here what would be the reason for the CT failure? 

2 Answers  


it is possible to run 130V AC and 230 V AC cables run in same tray

2 Answers  


How to setting the volume of RTCC panel AVR (11kv) controller

0 Answers   CNF Automotive India,


wht is embedded systems? what is new inthis field?

0 Answers  


Hi i want to know that in generation station what we are generate either voltage or current

1 Answers  


How can we calculate C10 rating of a bttery from c5 or c20 ratings??

1 Answers   Intel,


What is the difference between ground and neutral ?

2 Answers   TCS,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)