i am trying to select the correct grade steel for a shaft that will have a fla

i am trying to select the correct grade steel for a shaft
that will have a flap on it weighing about 4.5 tons being
forced up with hydraulic rams. can someone tell me what
grade the shaft should be and if it should be stainless
steel or not

Question Posted / j.hodson

2 Answers
4523 Views
Rainford EMC Systems, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

i am trying to select the correct grade steel for a shaft that will have a flap on it weighing abo..

Answer / sahil salota

yes it should we stainless, because the corrossion is
decreas the life of the steel or strenth.

Is This Answer Correct ?

2 Yes

0 No

i am trying to select the correct grade steel for a shaft that will have a flap on it weighing abo..

Answer / a. parimala

yes. it must be a SS material. The Shaft Quality will Be SS 316 L.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

what is 1st angle & 2nd angle drawing difference?

2 Answers ITC Infotech, L&T, Mercedes Benz,

what is the advantage of high pressure boiler & what is effect on steam consumption?

1 Answers Electrical,

What is cavitations?How it is generated?

4 Answers KFCL,

What are the causes of damage to propellers?

0 Answers

What are the items to inspect after cylinder liner is pulled out

0 Answers RRB,

Define convection.

0 Answers

1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?

1 Answers Infotech,

how to work on angular contact bearing? And which type load it take.

2 Answers

2/10=2

3 Answers Ford, TATA,

hi if anyone have ntpc q previous year ...send me yogessuccess@gmail.com

0 Answers NTPC,

Hindustan petroleum placement papers.please send me.

2 Answers HPCL, HSBC, NTPC, Satyam,

What is the formula to calculate the rating of a air compressor.

2 Answers

For more Mechanical Engineering Interview Questions Click Here