while stroke checking of a linear control valve ,found its travel is in non line

while stroke checking of a linear control valve ,found its travel is in non linear ,what can be possible reason ? ( please answer send in mannanali65@gmail.com) pls pls pls if any body know

Question Posted / mannanali65

2 Answers
6558 Views
JAL International, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

while stroke checking of a linear control valve ,found its travel is in non linear ,what can be poss..

Answer / md altaf

If your ccontrol value was nonlinear 1st you check the strock was set same(set back side of your positioner) as your control(wrriten on your control valve body).
2 and step was after equalise the stock then you adjust span and zero.
After you set the span and zero the control valve was working in normal condition.

Is This Answer Correct ?

1 Yes

0 No

while stroke checking of a linear control valve ,found its travel is in non linear ,what can be poss..

Answer / carl_ellis

The positioner is configured for quick opening, equal
percentage, or some custom non-linear characterization.

Carl Ellis
Measure First

Is This Answer Correct ?

3 Yes

4 No

Post New Answer

More Instrumentation Interview Questions

Can I put my meter across an RTD to check it safely witout tripping the equipment when it is connected to an monitoring device eg.RTD module or IQ 1000

1 Answers

How can you convert an SR Flip-flop to a JK Flip-flop?

1 Answers

WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN

0 Answers

what is differnace between radar level tranmitter & hart type tranmitter?

3 Answers

how to calibrate control valves & power cylinders & ultra sonic level transmitters

0 Answers ABB,

A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg. This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor. And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM. The question is : If the motor speed is +5,500 (RPM), what will be the temperature? (-sign indicates that the motion is in reverse direction).

9 Answers

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers

why 1 to 5 vdc is used for output measurment

4 Answers

How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?

0 Answers Almeer Technical Services,

HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?

0 Answers Chevron,

How to convert Differential pressure to flow in TPH

0 Answers Chettinad, ELCO,

what is the difference between Ethernet unmanaged and managed Switch?

2 Answers

For more Instrumentation Interview Questions Click Here