Answer / kunal pawar

To calculate the voltage drop of cable full load current need to be consider with length of cable, m/v/a of cable, nos. run of cable.

Answer / ameen

Thanks for ur response

I said same answer but interviewer told me we can take panel size bcoz if more than full load current flow in the cable panel ckt breaker will not trip(panel rating higher than full load current)at that time voltage drop calculation is wrong.

full load current is correct or panel size?

i need circuit star delta connection?

1 Answers   L&T,

---

What is the effect of positive feedback on stability of the system?

0 Answers  

---

what is the working principle of contactor and conditions of normal open and normal close on it?

3 Answers   EEE,

---

either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?

0 Answers  

---

WHAT HAPPENS IN DIFFERENTIAL PROTECTION IF CT REACHES ITS KNEE VOLTAGE POINT?

4 Answers   Jindal,

---

How can we measure the frequency of a rotor running in full load condition? Explain the method of measuring.

2 Answers   Wipro,

---

ouestion for the post of section engineer

1 Answers   BSNL, RRB,

---

What is Primary and Secondary Injection Test of CT and Relay.

2 Answers  

---

What is pole of the system?

0 Answers  

---

Can a 150 kva 3 phase,440v/230v delta-wye connection stepdown transformer can be used in reverse as a step up tranformer ?

3 Answers   Meralco,

---

wat will be the pressure maintained inside the transformer?

2 Answers  

---

hoe to test voltage restrained overcurrent relay?

2 Answers  

---