Answer / maurilio

If two or more transformer are connected in parallel the
output voltage will be the one on the transformer plate
as an example if the trafo is a 100 V input and 10 volts
output the output voltage will be 10 volts
If we connect two trafo like the one in the example in
series
we divide the 100 volts input on two trafo so the
output voltage will be only 5 volts

Answer / debasis paul

Transformer always done in parallel connection because when two or more transformer connected in parallel it is work depends up on the impedance. so that will not possible for series connection.

When two or more transformer are connected in parallel then increase load current but load voltage to same.

Answer / karna

Transformer is a voltage source, So voltage source always
connected in Parallel, it not possible to connect in
series ...

What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?

0 Answers  

---

if there is a voltage difference between neutral and earth when we operate any instrument for fraction of time then where is problem?

1 Answers  

---

Wind mill

0 Answers   Suzlon,

---

what is resistor

9 Answers  

---

Can you any explain about active,reactive and apparent power in power system with example.

1 Answers  

---

What is the exact formula for one weber of magnetic flux?

0 Answers   Bhel,

---

Generally we denote power in 'p',voltage in 'v'but why can't we denote current in 'c' instead of I.

4 Answers   Bhel,

---

what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks

0 Answers  

---

When in a large power system if the demand of power is larger than the generated power the frequency of the power system drops.(assume the rated frequency is 50Hz and now it is 49Hz) So does this mean the demand is totally supplied with a lower value of generated power in a lower frequency?

1 Answers  

---

How we calculate the size of H.T cable for any transformer & rating of busbar for any L.T. panel?

3 Answers  

---

why is electricity produced and distributed in multiples of 11. 440V, 11KV, 22KV, 132KV etc

2 Answers   Bhel,

---

Why transmission line carryiny high voltage and low current?

3 Answers   apspdcl, Universal Power Controls,

---