Answer / meka sekhar

three phase over laod relay can also be used for single
phase also. In this case, three overload relays shall be
wired in series with single phase circuit. The current
flowing through this relays will be detected whenver over
current flows and trip the breaker.

Answer / karna

In Three Phase relay Three terminals are there , use two
terminals in series with phase and one terminal for
Netural . Why we are connecting like these because balance
current will flow in the relay, then only if any fault(
O/L, E/L) occur it will trip

what happens in a genarator when rotor supplied with ac instead of dc

3 Answers  

---

power requirement of an l.e.d?

2 Answers  

---

At what factor resistance r of a conductor depends?

0 Answers  

---

Why DG self motor winding burnt out?

1 Answers   Aegis,

---

Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?

0 Answers  

---

what is thresold of perception

0 Answers  

---

WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM

0 Answers   RasGas,

---

What is ics,icu,icw of load breaker

5 Answers   Havells, NPCIL,

---

what will happen if ac motor given dc supply?

1 Answers  

---

hi, is there a difference in choosing bus bar for DC or AC ,,if there can anyone help me about. thanks

1 Answers  

---

For 7.5HP motor 2880rpm 415VAC Connected with Pressurisation Fan we used Star Delta Startor why not we use DOL startor

2 Answers   DLF,

---

using in R,Y& B PHASE LTSIDE(415V)ct ratio 4000/5 WITH ENERGYMETR OF 1280 REV./KWH,240V.WHAT WILL BE MF OF METRE.

1 Answers   HCC,

---