If anybody have the ref. design book of the 3 point
cylindrical rolling with sheet thickness of 2.3 mm & 67 mm
internal diameter legth of 80 mm
No Answer is Posted For this Question
Be the First to Post Answer
What is difference between AHX AND AH when referred to Withdrawal sleeves ?. Can we use AHX withdrawal sleeve with CK bearings ?
what do you mean by resistivity survey of tubewell
What should you do before you start the engine?
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
a cylinder, which length is 750mm and dia meter is 200mm, so find out a volume of cylinder ?
why more extraction are resticated in steam turbine?
what is mean by CONCENTRICITY? how it is measure?
11 Answers Greaves, Maha Enterprises,
Explain why is thick steel wire stronger than thin steel wire?
What is the differance between Quality Assurance Plan & Inspection Test Plan
What is ferrite material?
i am trying to select the correct grade steel for a shaft that will have a flap on it weighing about 4.5 tons being forced up with hydraulic rams. can someone tell me what grade the shaft should be and if it should be stainless steel or not
2 Answers Rainford EMC Systems,
Name any four commonly used refrigerants.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)