In which of the following is an operational amplifier
(op-amp) used?
a. Oscillators
b. Filters
c. Instrumentation circuits
d. All of the above
- 4 Answers
- 5566 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
oscillators can made by using op-amps. ex;wein bridge
oscillator. in instrumentation also uses. iin filters also
used as a subtractor. the unwanted is given to the inverting
terminal and total signal is given to the non inverting
terminal. output is wanted nothing but filtered.so answer is
all the above.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / unknown
Some circuits may use Positive feedback and Negative feedback around the same amplifier, for example Triangle wave oscillators and active filters
| Is This Answer Correct ? | 0 Yes | 0 No |
what must be the kind of test on innovatronix
What do you understand by reverse saturation current of a diode?
what is the ideal resistanceearth and why?????????????
what is the difference between electrical and electronic choke.. and whats the main advantage of elecronic choke?
Explain the difference allen bradley and siemens plc
what is BGA? what is the use of BGA?
Explain why does sidebands vl come in case of analog modulation?
equation for pid controller?
what is polarisation o antenna ?
What is cache coherency and snooping
What do you mean by Frequency re-use?
An FM receiver has an IF frequency that is A 88MHz-108MHz range B 540kHz-1640kHz range C 455kHz D 10.7MHz
-
Civil Engineering (5085) - Mechanical Engineering (4452)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
