where using the 0-20ma in feiled instrumentation? why its using?

4 Answers  

---

please tell me five types of fault of control valve and positioners?please

1 Answers  

---

what should be the distance of vibration sensor & to the point where vibration to be measured Ex turbine axial displacement

3 Answers  

---

what is the reason for flow fluctuations happen on differential flow transmitter during in service

2 Answers  

---

How to interfacing microcontroller with a DC motor

0 Answers   JJ Tech,

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers  

---

HELLO FRENDS ,, I M IN THE MIDST OF TROUBLE .. JUST LITTLE HELP ME... SUPPOSE ,, I HAVE A CLOSE VESSELE TANK ( HEXANE MEDIA ) ,, I M USING ROSEMOUNT 2051 DPT FOR LEVEL APPLICATION .. ITS CALIBRATE RANGE IS.. . 0 TO 950 MMH20 ..I DID CALIBRATED DPT WITHOUT REMOVING IMPULSE LINE OF HIGH AND LOW TAPPING.. & WITHOUT DISTURB 3 WAY MANIFOLD..!!! BUT ,,, DURING CALIBRATION I SELECT RANGE BY HART LRV IS 900 MMH20 & URV IS 1300 MMH20 ,, BUT ,TANK LEVEL SOMETIMES 100 % AT 1100 MMH20 , SOMETIMES 1300 MMH20 ..IN THIS CONDITION .. WHOLE LOOP FAILED ,, MAIN THING IS THAT ,, HOW TO CUSTOME RANGE SELECT ?? AND IF I USED RANGE OVER THE ORIGINAL CALIBRATE RANGE ,,,THEN WHAT ERROR WILL BE COME ??? HOW TO ZERO CALIBRATION OF DPT... HOW TO ZERO TRIM BY MANIFOLD ?? AND FOR TANK LEVEL PURPOSE ... WHICH UNIT I CAN USE ??? IS THERE ANY CALCULATION OR CALIBRATION .. IF YEH .. THEN PLZ JUST GIVE ME CALIBRATION STEPS FOR DPT.. THANKS YOURSSSSSSS

1 Answers   Torrent Pharma,

---

How we are deciding while programming in pid controller , What we are using heating or cooling.

1 Answers  

---

Please any one can explain how to calibrate transmitter (smart) online with out remove from the container suppose it is interface level or static pressure level measurement we dont want to remove transmitter from the container mean it is running plant please give me detail. thankx brothers

1 Answers   KNPC,

---

what is flow and flowrate? definate and diffrentiate it? pls post a valid ans thanks in advance

2 Answers   Qatar Gas,

---

how to calculate interface capelary level transmetar lower S.G.0.54 and uper S.G. 0.26 and h=490 mm

3 Answers  

---

Which type of pressure can be measured by primary elements?

0 Answers  

---