How can conclude that whether it is gravity die casting component or pressure die casting or low pressure die casting and shell moulding?

1 Answers   Fenner, TVS,

---

What is the need for drafting?

3 Answers   CADD,

---

What type of job are you holding at the moment? What is your desired employment / occupational field

0 Answers   Radisson Blu,

---

will stress be induced in a material if it expands freely???

3 Answers   Bhel, HAL, TCS,

---

If a fixed gear having 200 teeth is in mesh with another gear having 50 teeth.The two gear are connected by an arm.What will be the number of turn made by the smaller gear for one revolution of arm about the center of bigger gear? Any effort is appreciable witha proper logic..

8 Answers  

---

Re: what is different between run out and concentricity in Gd &T

0 Answers  

---

How do you convert feet into square feet?

1 Answers  

---

Why is thick steel wire stronger than thin steel wire?

0 Answers  

---

what is pulverisation

6 Answers   GNFC,

---

how a disel engine works in generator? explain with labelled diagram?

2 Answers  

---

Why do not use flywheel in petrol engine

4 Answers  

---

The higest value of thermal conductivity is expected for a.) Solid ice b.) Melting ice c.) Water d.) Boiling water Give the thermal conductivity value for each.

2 Answers  

---