how much type question asking sulfuric acid plat interview. if not maintain aci

how much type question asking sulfuric acid plat interview.
if not maintain acid temp. and conc. what will happen

Question Posted / pandey_atulesh

1 Answers
5086 Views
I also Faced
E-Mail Answers

how much type question asking sulfuric acid plat interview. if not maintain acid temp. and conc. wh..

Answer / astik gedekar

It is most important to maintain the temp. And acid strength for h2so4 production, if acid concentration high then so3, not absorb in molecules of water present in sulphuric acid, that means lot of stack eemission. 2 Is if low concentration of acid lot of heat is generate and due to heat absorption can not ddon, and it increase the pressure drop in absorption tower.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Chemical Engineering Interview Questions

How can one determine the particle size distribution for a given bulk solid?

0 Answers

Is there a quick rule-of-thumb to estimate a gas side heat-transfer rate inside the tubes of a shell and tube heat exchanger?

0 Answers

Why whenever a reciprocating compressor is switched ON or OFF it is put into unloading mode?

0 Answers

What is the best way to configure a bypass line in slurry services?

0 Answers

how much maximum power can be generated by 320v, 10kg-cm synchronus motor if shaft is roteted mechanically at 50 to 60 rpm?

0 Answers

Explain how can one quickly estimate the additional pressure drop to be introduced with more tube passes?

0 Answers

What are the different characteristics that can affect the flow of bulk solids and how?

0 Answers

QUANTUM CHEMISTRY AND CHEMICAL ENGINEERING - EXAMPLE 31.10 : There are 6 spin orbitals in p subshell in a ground state carbon atom. Only 2 electrons fill the p subshell. Number of different ways for n electrons to occupy the k spin orbitals are k! / [ (n!) (k-n)! ]. Find the number of different configurations of electrons to occupy the p subshell in a carbon atom.

1 Answers

What are the effects of oils on the properties of Polyolefins?

0 Answers IOCL,

BIOCHEMICAL ENGINEERING INSTRUMENTATION - EXAMPLE 29.5 : The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.

1 Answers

Explain what is a quick way to calculate frictional pressure drops in carbon steel pipe?

0 Answers

Why do we apply on iron articles?

0 Answers

For more Chemical Engineering Interview Questions Click Here