I Have 100Ah battery with 650VA Inverter, i WANT TO TAKE a
Solar panel to charge my battery, so please suggest me,what
rating of solar panel(with solar charge controller) can buy
for a load of 450w for 4 hours



I Have 100Ah battery with 650VA Inverter, i WANT TO TAKE a Solar panel to charge my battery, so ple..

Answer / s.sakthivel perambalur

780 VA ro market available equlant 800VA solar charger is better

Is This Answer Correct ?    1 Yes 2 No

Post New Answer

More Electrical Engineering Interview Questions

What is VCB'S @ ACB'S.Plz explain Briefly

2 Answers  


WHAT IS MODULATION AND NEED FOR MODULATION ?

1 Answers  


a 440v 60hz 03 phase 100kw generator can deliver how much power in kw for 220v 60hz 01 phase load?

1 Answers  


what happen if the battery is charged by more than one source ,for ex: connecting data cable to laptop & charger pin to source supply ? 

2 Answers  


how to calculate diesel consumption of a D.G.Set?

4 Answers  






how to give earthing in ships?

1 Answers  


In a circuit a capacitor (paper capacitor ) was burned due to over voltage in this case can we replace that type cappacitor with other tye capacitor ?

1 Answers  


for a slip ring induction motor if the stator is short circuited and rotor is given supply? how does the rotor rotate?

1 Answers   TNEB Tamil Nadu Electricity Board,


please can i know about total harmonic distortion and how i can calculate it and if anyone can help me to find any program to help me to calculate THD?? please need it

1 Answers  


Why Motors are generally supplied with 3 core cables??? why not 4C??

5 Answers  


Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers  


why overload relay is not tripped at time of starting of motor allthough staring current is too high?

5 Answers   TATA,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)