In legging current reactive power is arise but in leading current which power wi

In legging current reactive power is arise but in leading current which power will be arise ? and in this case, is active power more than rated ?

Question Posted / pradyumna chandra panda

3 Answers
5569 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In legging current reactive power is arise but in leading current which power will be arise ? and in..

Answer / najeeb khan

yes reactive power increases with increase in leading
current and legging current both.

Is This Answer Correct ?

1 Yes

0 No

In legging current reactive power is arise but in leading current which power will be arise ? and in..

Answer / vanthni@yahoo.com

what is your doubt

Is This Answer Correct ?

0 Yes

0 No

In legging current reactive power is arise but in leading current which power will be arise ? and in..

Answer / raza

Reactive power is arise at both lagging and leading power
factors. But at lagging power factor, reactive power will be
positive and at leading power factor, reactive power will be
negative. At the same power power factors of lagging and
leading, no change in active power.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

The basis on which voltage selection of motor is done i.e. either HT or LT.

1 Answers DAE,

How does the humidity affect in breakdown voltage of air?. Is the breakdown voltage increases with the humidity?

2 Answers

IN A SMALL D.C GENERATOR, IF WE REPLACE THE LAMINATED CORE ARMATURE WITH A WOODEN BLOCK OF SAME SIZE & SHAPE AND WIND WIRES WOUND ON THE SLOTS OF WOODEN ARMATURE AND CONNECTED TO THE COMMUTATOR.COMMUTATOR IS FITTED WITH BRUSH TO RECEIVE INDUCED E.M.F.WHETHER E.M.F GENERATED OR NOT?

3 Answers

anybody can give the voltage value for 1M ohm

2 Answers

checking procedure of capacitor based motors.used in fans etc?

0 Answers Badve,

what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?

0 Answers TNEB Tamil Nadu Electricity Board, Vestas,

How will you calaculate the Ct ratio based on connected load 500KVA,and 11KV supply ?

3 Answers

Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter

0 Answers

what is diffrent of RCCB & MCCB

6 Answers

Why earthing done?

1 Answers CBRE,

I have tow 200 KVA UPS, both are in parallel mode.My question is that, both are running on battery when power fail, if one of them fail (Eg rectifire fails or some other reason), at thet time reverse power will come to faild ups if it comes then it will harm to failed ups or not? if not then how it protects to faied ups????????????????

1 Answers

Dir sir we have 750 kva Caterpillar dg set we are fas on different problem we start dg set ofter 1 mint apply load around 500a dg was run one or 3 mint after 3 mints dg was shutdown automatic how to face tis problem

3 Answers

For more Electrical Engineering Interview Questions Click Here