1) How a router established a neighbor relation ship in ospf
Answer / cheralu kankala
through multicast ip 224.0.0.5 hello messages
| Is This Answer Correct ? | 4 Yes | 0 No |
Which type of switching reads in the entire frame before forwarding it? A.) Pause-and -forward B.) Store-and-Forward C.) Inverse ARP D.) Fast Forward E.) Cut-Through F.) Routing
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable
How many valid ip will b in /21 in route summarization?
I want to configure a serial interface on a 7500 with a VIP card. What global config command would give me access to a serial interface on a 7500? A.) int 1/0/0 B.) int s 1/0/0 C.) int s 1/1 D.) int s0.1 E.) int s1
Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book
why we give clock rate to DCE and not to DTE what is the difference in the two.
Which mode called privilege mode?
Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP
FastEthernet compares to 10baseT Ethernet in which of the following ways
what are the port numbers for DNS,FTP,TELNET,SMTP,NNTP
5 Answers Airtel, Walton Group,
Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network