Can you explain PAP?

0 Answers   CCIE,

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

1 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton

3 Answers  

---

When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

2 Answers  

---

Identify the command mode necessary to enter the standard ping command? A.) Router(config)# B.) Router> C.) Router(std-ping)# D.) Router(config-if)#

2 Answers  

---

When using access lists, what does a Cisco router check first? A. To see if the packet is routable or bridgeable B. The destination address C. The source address D. The packet contents

1 Answers  

---

Which of the following is used to manage and monitor the network? A.) SNMP B.) HTTP C.) IP D.) FTP

1 Answers  

---

Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43

1 Answers  

---

Which can be logged by IPX extended access lists? A.) source address B.) protocol C.) source socket D.) access list number E.) destination socket F.) destination address

1 Answers  

---

What is the difference between arp and rarp?

0 Answers  

---