Answer / ravindra kumar

50 times the dia of the bar

Answer / vijay kumar

Overlap length of reinforcement by wielding is 15d i.e 15 times the diameter of bar. Wielding will be carried out for Top 5d and bottom 5d. i.e there will be a gap of 5d in between.

Answer / francis etaunuburhon dale

Overlapping length is based on the factor of 40 times the
diameter of reinforcement to be used.
example, for 20mm diam steel reinforcement the lap length is
800mm

which member is very strong (strength) after the cross- section area is same, pipe section or solid rod section ? no that's not my question, my question is why pipe section is strong ?

2 Answers  

---

how many covering can be taken in the beam,column & slab also stair-case?

6 Answers  

---

what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix

1 Answers  

---

best hand book for civil engineers with practical criteria

2 Answers  

---

How and where are aqueducts built?

0 Answers  

---

RR masonry rate analysis

0 Answers  

---

What is the Requirements of indoor & outdoor Substation Construction? What is the main Safty Requirements for SubStation Construction?

1 Answers  

---

How to calculate quanty of steel in four leg stirrups?

0 Answers   INT,

---

what r the precaution for high in atp tempareture,low in atp tempareture

0 Answers   NSL,

---

WHAT IS MIS REPORT?

1 Answers  

---

If we use oil,inner on the column box, it'll make rust on the column steel?

4 Answers  

---

usually hand broken stones are used for cement concrete 1:4:8 in foundation of single /two story houses with a view of economy in construction.what advantages it will give if you use machine crushed stone in place?

0 Answers  

---