Answer / sloke

To reduce the flux loss in transformer

Answer / guest

because there is no other type of transformer

How much no load current of synchronous motor

0 Answers   Nirma, Sulphur Mills,

---

How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.

0 Answers  

---

in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

0 Answers  

---

Why the brushes used in dc machines are made of carbon not from other metal?

3 Answers  

---

why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?

0 Answers   Grasim,

---

---

how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor

0 Answers  

---

my motor rating is 800HP, 128Amps, 3.3kV. What is capaitor bank i can use for PF improvement to 0.990?

3 Answers  

---

If we know the load for generator in KW then how it will be change to amps and also if we know the load in amps how it will change in KW and what Generator is good for that...suppose load is 500 amps 3phase......??

1 Answers  

---

What is the lockout relay

0 Answers  

---

i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400

0 Answers  

---

Essential condition for parallel operation of two single phase transformer is that they should have same A polarity B kVA rating C voltage ratio D % impedance

1 Answers   wbsedcl,

---

where AVR is connected in power plant.

7 Answers   ABB, Saudi Red Bricks,

---