1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?

1 Answers   Infotech,

---

At 50 Centigrade (Diesel oil) what is its cast?

0 Answers  

---

difference between rolling & pitching

2 Answers  

---

what is punching force required for embossing of depth 3.5mm and diameter 58mm

0 Answers   Omkar Solar System,

---

Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

0 Answers  

---

Who are the leaders among expansion valve manifacturers? what are the recent developements in the expansion valve industry, used in refrigeration abd air-conditioning?

0 Answers  

---

i have completed b.tech from mechanical engg so plz send me some question paper for entrance exam

0 Answers   Shipping Corporation of India,

---

Categories >> Engineering >> Mechanical Engineering Suggest New Category Question Asked @ Answers Views select what is advantage of hllow shaft over solid shaft aprt from material saving? does hollow shaft absorb more vibration than solid shaft? 0 5 wat is the meaning of cop of wet suction and dry suction????? 1 171 What is the difference between an axle and a shaft? reply soon frnds........ 4 260 16 inch = 1 ______________? 2 124 What are the steps taken in troubleshooting of a machine e.g extruder ME 0 26 What is a seal? ME 3 133 what is the mean of b.tech? 3 167 what type of pump 2 63 what is differance between ball screw and lead screw ? Amtek 1 86 What is the units of surface tension and also dimensional formula? RRB 3 218 What is meant by cigarcone? RRB 3 120 I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons 0 24 why steam power plant is more popular than gas turbine plant? ME 3 304 what is EEE in thermodynamics????? ME 2 223 what is the practical use of ENTROPY? JSW 4 282

1 Answers  

---

1. Centrifugal pump is used to drain the coolant from the machine to coolant tank via magnetic separator and paper filter. But more foam is raising in the coolant tank. We need to arrest the foam formation inside tank which is nt desired. How do we correct this issue? (Hardness of the water is at recommended ppm).

2 Answers   Nissan,

---

i have an iterview on 18 sep for bhel ,pls send some questions asked during interview during the earlier interview on 11th sep

0 Answers  

---

How to calculate the quantity of Grease applying in all bearing?is there any fix formula for this.

2 Answers  

---

What is vane diagram in centrifugal pump?

0 Answers   Tata Steel Limited,

---