which utility should use to test whether TCP/IP has been
initialized on a system.friends plz post the answer with
explaination..
Answers were Sorted based on User's Feedback
Answer / nageswar
type netstat in command prompt it show list of protocols which
are online and in use
Is This Answer Correct ? | 18 Yes | 0 No |
Answer / nageswar
To check whether Tcp/Ip working try to ping loopback network
i.e; 127.0.0.1-255,if echo Packets aren't received Tcp/Ip is
not yet initialized cause icmp works on Tcp/Ip only
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / sudharshan
when we type netstat cmd you may see how many protocal working in our ip and how many foreign address we are connecting with which protocal we know like http and ftp
Is This Answer Correct ? | 4 Yes | 2 No |
Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended
Can you explain PPTP (Point-to-Point Tunneling Protocol)?
Which two statements about the store and forward switching method are true? (Choose two) A. Latency remains constant regardless of frame size. B. Latency through the switch varies with frame length. C. The switch receives the complete frame before forwarding it. D. The switch checks the destination address as soon as it receives the header and begins forwarding the fram immediately.
Which cable called roll-over?
what is the major difference between EIGRP & IGRP?
What is Spanning Tree Protocol and how it work? I know it is - STP is Spanning tree Protocol. It Stops the looping in the network? How STP work? How it stop Looping in network?
Which technology is used by Catalyst switches to resolve topology loops and ensure data flows properly through a single network path? A. virtual LANS (VLANS) B. frame filtering C. cut-through switching D. spanning-tree protocol
You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router
Can we write any script for router to instruct that from where it will boots e.g. TFTP,FLASH...if yes what is it and how? 1 of my frnds says its possible...
What is default size of hello packets in ospf?
Can you explain what IPSec is
What is difference between routing and routed protocols?