Answer / junaid

1)The spacing of bars it depends on design of steel as well
as lengh of area.
2)Slab beams & slab including columns the design depend on
Dead Load,Live load,wind load as per this we are designing
steel.

What is the meaning of Brick- M 35 grade? Is it a common brick or it's a concrete brick?

0 Answers  

---

how many area req.in 15000liter water tank

7 Answers  

---

factory shed foundation l=4, b=3' d=8' rcc foudation for top to bottom pl tell me cement ,steel ,sand ,labour cost ,excavtion,soil is weak not so hard

0 Answers  

---

what is the difference between np2 and np3 concrete mix

0 Answers   Sri Matha Constructions,

---

from one meter cube of stone masonry structure how much cubic meter of cement mortar we use as our estimation 25-30% is that correct for estimation of quantity of sand and cement(2:1) proportion of mortar

0 Answers  

---

---

how do you calaculate the total steel quantity of an rcc building using thumb rule?

0 Answers   L&T, SSC,

---

How Can Calculate Plastering Quantities For 260.04 square meter by using CM 1:4 with 25mm Thick ?

2 Answers  

---

how can we calculate costing of a project per sqft/sqm

1 Answers   Associate Consultant, AVT, L&T,

---

What materials were used to build the golden gate bridge?

0 Answers  

---

specifications of fe500 steel

0 Answers   L&T,

---

WHAT R THE GENERAL TECH QUESTIONS ASKED FOR THE INTERVIEW FOR AN AUTOMOBILE INDUSTRY,SPECIALLY DESIGN DEPT

0 Answers  

---

Do you know differenence between design mix and nominal mix?

8 Answers   L&T,

---