what are the particle used along with silica gel in
transformer breether,explain their functions.
Answers were Sorted based on User's Feedback
Answer / sakthivel
when ever transformer oil temperature increase time,
transformer inside hot air goes in to out side of the
transformer, by root of conservator tank,
similarly transformer oil temperature decrease time,
normal atmospheric air goes in to transformer, by root of
breather ,
the normal atmospheric air contend of moisture ,
basically the moisture air mixing time transformer oil is
reduce the breakdown strength ,
breakdown strength reducing time electrical fault developed
in side of the transformer,( earth fault,phase to phase
short circuited ),
basically silica gel to arrest the moisture in air so we
are use silica gel used in breather (are u understand,
vanthni@yahoo.com)
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / syed
we use transformer oil along with silica gel in the
breather of the transformer to absorb the dust from the air.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / sakthivel
silica gel chemical name is calcium silicate this in 2
answer(your technical suggestion forward to vanthni@yahoo.com)
| Is This Answer Correct ? | 0 Yes | 1 No |
Answer / 3nath
generally silica gel is in blue color,
it is used to observe the moisture in
atmospheric air, after getting moisture
it will appear in white color
| Is This Answer Correct ? | 2 Yes | 4 No |
when we supply in primary side of transformer then the supply goes in secondary side?how it works?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
Define transfer function?
what is meant by HT<?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
Difference between online and offline UPS?
What is the formula to find out two phase active & reactive power
why dc supply is given for excitation of ac alternator?how dc can produce flux?
what is the difference between LPF and UPF wattmeter and where it is used.
iam completed my DEEE in eillm university. can i get the c licence in tamilnadu its possible or not
what is the reason of current flow in nutral although load is balanced (three phase equal current)
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)