WHY IS wet surface used for grounding???

Question Posted / ankurbharadwaj2223

2 Answers
4861 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

WHY IS wet surface used for grounding???..

Answer / k.prakashchandra

There will be better contact between the surface of the
electrode and the material surrounding it, resulting in
reduction of ER

Is This Answer Correct ?

4 Yes

1 No

WHY IS wet surface used for grounding???..

Answer / manilal.r

It may be achieve good
coductivity,that is more
elctrons can pass
spontanioucly.....There by
power ratings can also
improoved

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

WRITEDOWN FEW RELY CODES

0 Answers Equate,

what is the safty of poly phase tranformer?

0 Answers Adani,

10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)

0 Answers CTS, Jindal,

HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER

0 Answers

what is the full form of ka (100A mccb KA)

1 Answers

why dimmerstate always connected in star connection? what will happen if it connected in delta?

0 Answers

Where to use pt and where to use CVT

2 Answers

What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.

0 Answers

How to calculate PF capactors for a connected load?

2 Answers FD, Power World,

If Earthing is poor in a DB of of Residential Building, will residents feel a leakage voltage in a Electrical Ssytem? is this statement true?

1 Answers Dolphin International,

Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?

0 Answers

In a company has been installed an analog amperemeter, this company was suplied by generator X, there is no problem in the ampere meter, rigth now this company's supplied by generator Y then the pointer in amperemeter vibrating. What happened? Why? Thank's

2 Answers

For more Electrical Engineering Interview Questions Click Here