Answer / nilesh

Temperature close loop needs temperature sensor(
RTD,Thermocouple etc),controller ( Local/DCS/SCADA)and
final control element ( Control valave,Heater etc..).We
have to give SP to controller which measure the temperature
with sensor and actuate final control element as per
requirement.

How to rerange a dp type level transmitter after installation?

1 Answers   NSH,

---

how many types of sensor in instrumentation

3 Answers   SRACO,

---

Instrumentation engineer please reply me,I am electrical engineer ,what is the future in instrumentation dept {presently working (P&ID) Design} for me,whether good future for me as instrumentation department.what side can i get job in future

3 Answers  

---

What should be the ideal tapping location for pressure differential transmitter for liquid service. If the tapping taken from the top of the pipe then PDIT will work properly or not. If PDIT do not work properly then what minimum corrective action should be taken in order to solve wrong tapping locations.

1 Answers  

---

how to calculate range of level transmitter?

0 Answers   TCE,

---

I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.

0 Answers  

---

What happens if the Displacer has fallen or has a hole in it?

1 Answers   CCIE,

---

Draw a group of instruments interlocked to a Pump & Motor?

0 Answers  

---

what the pid setting in controller

2 Answers  

---

How servomotor controls throttle valve of TURBINE?

0 Answers  

---

what deference between panel earth and systemearth

0 Answers   Tecnimont,

---

what is working principle of vibration prob

3 Answers  

---