Why are calling lagging power factor is a inductive load?

Question Posted / jeevitha083

2 Answers
5128 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why are calling lagging power factor is a inductive load?..

Answer / k.prakashchandra

Just because the current is lagging the voltage

Is This Answer Correct ?

3 Yes

0 No

Why are calling lagging power factor is a inductive load?..

Answer / kotike chaitanya bharghav

In case of inductive load
the current will lags the
voltage always.....!!
so there is reduction in
terminal voltage .....!!!
so there is always lagging
power factor in the case of
inductive load
(the phasor diagram will
show the correct
explanation)
in inductor magnetic energy
is stored so when it always
opposes the change in
current

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

in case dc we mark as + ve & -ve..but in case a.c. we mark as ph&N...Y LIKE PLZ TELL ME

4 Answers NPTC, TCS,

Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.

0 Answers

low frequency protection why recomend?

0 Answers

Which of the following are the important limitations of rod gap surge arresters? 1. They are not capable of selling off power frequency follow up current. 2. After a discharge, the rods are destroyed completely. 3. Performance is affected by climatic conditions. Use the following codes for selecting the correct answer. Codes: (a)1, 2 and 3 (b)1 and 2 (c)2 and 3 (d)1 and 3

1 Answers

1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be

0 Answers KNJ,

Why we need to carry out knee point voltage test of current transformer ?

1 Answers Power Grid,

what is voltage rise and voltage drop?

8 Answers HP, jetking, TCS,

acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO

0 Answers

I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?

0 Answers

how much watts are equal to one unit of energy meter?

9 Answers

why we use separate earthing for two seprate machine??

1 Answers

5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch

0 Answers

For more Electrical Engineering Interview Questions Click Here