FLP zone Types and Details
Answer / arup
ZONE 0 --Areas in which an explosive gases atmosphere (An
explosive gas air mixture) is present continuously or
present for long time.
ZONE 1---An area in which explosives gas atmosphere is
likely to occur in normal operation.
ZONE 2--An area in which an explosive gas atmosphere is not
likely to occur in normal operation and if it does occur,
it will exist for a short period only.
| Is This Answer Correct ? | 1 Yes | 0 No |
What is the equipment used to control the generator output?
house wiring - series wiring or parallel wiring
What different between kw and kva. why maser AC in kva.
What will be the current after disconecting the bus bar or cable before discharging ?
what is diffrence between neutral and earth wire
23 Answers Bhel, Esab, MTNL,
what is the responsibility of C license holder in industry?
how to select earthing conductor size of amy motor/panel etc.
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
what is active power & reactive power?
What is the basic rule for block diagram reduction technique?
For backup batteries connection,which method is best? series or parallel ?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)