transformer is working or not with supply of DC?

Answers were Sorted based on User's Feedback



transformer is working or not with supply of DC?..

Answer / prabhakar sankle

Transformer functioning only with a.c supply.Because there is need mutual induction in coil and core.It couldn't happen with DC supply.

Is This Answer Correct ?    10 Yes 3 No

transformer is working or not with supply of DC?..

Answer / pavan sharma

If dc supply is given to xmer then pri wdg has no recatance so impadance is low due to low resistance so dc supply burn primary

Is This Answer Correct ?    6 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

what is diffrent between plc and clc??

1 Answers  


In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?

3 Answers  


5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch

0 Answers  


If one ct is reversely connected in Y system what will effect in kwh and kvarh meter?

1 Answers  


Define motor & pump?

3 Answers  






why the efficiency of generator is more than the motor in case of swinburne's test????

1 Answers  


A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.

0 Answers  


why we step down the voltage from 440 to 220 in machines

4 Answers  


what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????

0 Answers  


How Arc Extinguish in Minimum oil circuit breaker and What is the function of Radial and axial vents of turbulator in Minimum oil circuit Breaker Where these vents are exists.

1 Answers  


I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.

0 Answers   Power Grid,


Hi friends. is it possible that SCADA System through RTUs can connect Via PLCC Communication carriers ? thanks

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)