How to choose the vector group for the step up and step down
transformers??? Tell me the which vector group is suitable
for step up and step down transformers and whats the reason
to choose and whats the benefits???
No Answer is Posted For this Question
Be the First to Post Answer
WHAT IS THE PARTIAL DISCHARGE TEST?
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
0 Answers Exide, Punj Lloyd Ltd,
What is the material used for the core of a high freiquency transformer?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is the test block protection relay if any body know plz explained
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
How the field flux is controlled in DC drive ?
When we give supply to a transformer 11 kv and we get 415v from it, so when we give supply to same transformer 415v on ht side what we get? and When we gives supply to any transformer to L.T. side 415v or 220v What supply is on H.T. side?
Why all voltage levels are the multiples of 11KV?
we want install 11KV generator to supply power 12km far from the power house.Load to be fed is 1MW.which conductor should we use and wat will be transmission line losses?
what is called inrush current??
Why is making current of CB always greater than CB breaking burrent?.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)