can a power plant work without condenser.
Answers were Sorted based on User's Feedback
Answer / anirban mukherjee
YEAH I THINK IT CAN WORK,BUT EFFICIENCY WILL BE MUCH LESS,AS IN CONDENSER WE CONDENSE THE STEAM TO A PRESSURE MUCH LESS THAN ATMOSPHERIC PRESSURE SO THE TEMPERATURE OF HEAT REJECTION IS ALSO MUCH LESS.WE KNOW THAT IF TEMP OF HEAT REJECTION DECREASES THEN THE EFFICIENCY OF THE CYCLE INCREASES.SO FOR GETTING BETTER CYCLE EFFICIENCY WE USE CONDENSER and NOTHING ELSE.
Is This Answer Correct ? | 7 Yes | 0 No |
Answer / tankadhar bhoi
yes,it's obvious that a power plant can work with out condenserbut the efficincy is much less.
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / awaken
in my view ,practically without compromising efficiency as
well suitability,power plant cannot work without
condenser.theoretically if plant supplies indefinitely
abundant quantity of working fluid at the inlet of
evaporator and is disposed after expansion in turbine.But
both its disposal as well as its continuous supply is
practically impossible and thus the best optimum soln is
condenser.
Is This Answer Correct ? | 2 Yes | 2 No |
Answer / pawan kumar
yes, hydro power plants work without any condensor.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / kuldeep
yes it can work,bt still capacitor banks are required to
provide the lagging kvar demands at the peak hours
Is This Answer Correct ? | 5 Yes | 7 No |
Answer / anunay kumar
yes work for more detail my e mail anu007rock@gmail.com
Is This Answer Correct ? | 2 Yes | 16 No |
hi if anyone have ntpc q previous year ...send me yogessuccess@gmail.com
Define laminor flow in fluid mechnics
why transformer required and why not voltage directly supply from power generation to the applications
What are the advantages of a centrifugal pump over a reciprocating pump?
What is the device that converts sound energy into mechanical energy?
What is the ADP&PDP in air dryer?
What is the formula for bearing OD?
How can be calculate discharge of id fan. impeller dia-800 mm,motor capacity 10 hp 2800 rpm,blower opening section 230*130 mm
Can I use IS 2062 GR B Material for low temperature application upto -20 C ?
why some shafts are drilled internally " mech stress point of view"
Name of the navratna copany of tha india?
How do you reset the circuit breaker?