Answer / k.prakashchandra

Single phase tr has two leads and there are at least 3 leads
for 3 phase supply. You can not connect without short
circuiting.

Answer / bala

only singe out will come from secondary of TFR

Answer / muhammad shoaib

single phase transformer will burn out bcz three phase
supply is so much high and use in industries.

how can we design robots

0 Answers   Maruti Suzuki,

---

How to model two generators into a single generator ? Eg. two generators connected to a bus, would like to model it as a single generator connected to a bus.

0 Answers  

---

For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!

0 Answers   Maruti Suzuki,

---

what are the protections used in power transformers of 5 mva and above

2 Answers   ESRI,

---

What are the loading factors to be considered for transformer sizing/selection?

3 Answers  

---

---

in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?

0 Answers  

---

ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.

0 Answers   ONGC,

---

what's the reson that,Load is not same on VFD I/P and O/P Side.whenever DOL condition load is same I/P and O/P side.

1 Answers  

---

bsec exam syllabus (mis)

0 Answers  

---

what is the difference between general inverter and solor inverter clerly explain plz

0 Answers  

---

How to calculate the multiplying factor for energy meter with ct ratio given

0 Answers  

---

When measuring the Insulation resistance of a motor winding (winding to earth) using a megger meter, Applied voltage(1000V) was automatically reduced to 500V. and the measured insulation resistance values are also very low (in Kohm range) Can anyone give me a reason???

3 Answers  

---