cause of failure of transformer bushes

Question Posted / somesh_kudupudi

3 Answers
5270 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

cause of failure of transformer bushes..

Answer / k.prakashchandra

Loose connection inside and contamination of oil in case of
condenser type bushings.

Is This Answer Correct ?

2 Yes

0 No

cause of failure of transformer bushes..

Answer / malay kumar

THE MAIN POINT IS DUE TO EXCESSIVE HEAT, THE REASON MAY BE AS LOSS CONNECTION,CONTAMINATION OF TRF. OIL WITH MOISTURE,WITH NOT PROPER COOLING, AND EXCESSIVE LOAD.

Is This Answer Correct ?

1 Yes

0 No

cause of failure of transformer bushes..

Answer / karolson

Transformer bush failure causes include:
1:use of of improper conductor on termination
2:oveheating of transformer either due excessively load or failure of cooling system or internal fault.
3:loose connection on bush
4:oil spillage on bush
5:rust and moisture

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Why USe In -48 DC Volt !

3 Answers

What is diversity factor.

2 Answers Cadbury,

what is the IS foe lightning arrester?

0 Answers

What happened when capacitor connect series in ac circuit?

0 Answers

i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com

0 Answers

In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.

0 Answers

why generator one end side star neutral point given? if this point not given what happen?

1 Answers

if u want to buy a motor than what will be the configuration of that motor?

2 Answers

What is meant by soft starter used in motors?

4 Answers

What is the full form of PSD & CSD ?

6 Answers NIFT, PNG Power, PSD,

In a 11kv/433v transformer,at the LT side ie 433 V side why do we need to put 3.5 core Cable upto Panel.The full load rated Amps is 666 at LV side.What value of current will flow through the Nuetral Conductor.Why can't we use 4Core Cable instea of that?

2 Answers

What is the difference between DOL starter and star delta starter

0 Answers

For more Electrical Engineering Interview Questions Click Here