why shunt capacitor is connected
Answer / swarnansu
we can get same operating voltage at less cost and when an
3ph short ckt fault occurs it will not increase the fault
since it cant send any energy to the fault point.
Is This Answer Correct ? | 0 Yes | 0 No |
Can we use MCCB with Auxiliary Contact in place of Contactor in a AMF System.
How efficiency of thermal plant can be improved?
Will The Rated Capacity of 20 MVA ,220/6.6 KV, ONAN cooling Power Tranformer be increased up to 25 MVA with respect to its %Impedence by ONAF cooling with same rating..?
what would happen when synchronous motor will operate beyond syncronous speed?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
What is Energy based relay coordination & time based relay co-ordination? In which type of distribution arrangement these methods are applicable?
Amoung all classes of electric machines, why the transformer uses oil as one medium of cooling?
What is the speed of electrical supply?
How to calculate voltage drop in copper and aluminium cable? I have laid 240Sq.mm Aluminium cable for the length of 600 Mtrs in 1 Mtrs underground. Normal load is 150A. Transformer is 630KVA, 6.KV/433V. But, I am getting only 395 Volts when load. How to calculate voltage drop and what is the permissible voltge drop for this circuit?
what is effect of length of air gap on performance of dc motor and generator?
Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?
The neutarl to earth voltage in system is 7volts on Electricity power but it lowers to 1.3volts when load transfered to DG power.what may be the reason.