Answer / bablu choudhary

If, we use LPT and HPT used for full STIG ,then volumetric flow rates of the turbine is to be constant to maintain the pressure ratio of gas turbine while the mass flow rates of the STIG is lower than that of gas turbine.

so compensation is not required in case of mass flow rate it only allow to flows the volumetric flow rate.


THANKS.

What is the reason PT speed not incresed in gas turbine?

0 Answers   ROC,

---

How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?

0 Answers   Matrix,

---

what are the following documents comes under loopchecking

1 Answers   Heisco,

---

what is solenoid valve?

1 Answers  

---

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

0 Answers   Chevron,

---

Describe how to use megger to measure the earth resistance and insulation resistance

0 Answers  

---

Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?

0 Answers  

---

Consider a level troll. i am getting a correct value in 4mA and 20mA. the value in the middle(30 to 60%)is disturbed and i am not getting the appropriate value. what is the solution to normalize the level and to get the correct value..

2 Answers   KNPC,

---

What are the type of bonnets in the control valves?

0 Answers   CCIE,

---

Basic working principle of control valves

1 Answers  

---

Why thermo wells are used?

1 Answers  

---

How to calibrate level switch?

2 Answers   Power Plant, Sabic,

---