hot water tank,top element 240v across,the bottom 120v
across,why?
Answer / k.prakashchandra
So that it can be used for both 1 phase 120 V and 240 V systems.
Is This Answer Correct ? | 0 Yes | 0 No |
How to megger test 11 kV cable and the acceptance IR value
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
why air handling unit interloking in case of fire
give me atleast four differences between circuit and network
Hi If connecting a temp generator 670KVA .415kv with step up Tx .415/11kv. I am given Generator impedances Z1 Z2 Z0 to 100MVA base. Do I need to work out the generator fault current by using these impedances i.e gen rating / impedance. Then use this as my source impedance for the calculations that follow.
what is first ground fault & second ground fault. This is used in rotor protection of alternator.
keeping in view of parallel operation which of the 3 phase transformer connection are possible? a)delta-delta to delta-star b) delta-delta to star-delta c) star-star to delta-delta d) delta-star to star-delta
what is the working principle of UPS?
What are the special cables required for explosion proof wiring?
why solinoid coil used in tripping rely?and why not other type coil?
State magnitude criterion.
Why use prefer Dc drive in place of Ac drive for kiln Operatio in Cement Plant?