Answer / sagar shinde

1.oxidation and intermittency of operation
2.Formation of hot spots
3.Embrittlement due to grain growth
4.Contamination and corrosion

Answer / n.k.singh.

1.If there is loose connection between terminations of heating elements,hot spot will be made which leads to failure of heater.
2. If reaction takes place between heating element and surrounding atmosphere,i.e. corrosion of heating element which leads to poor heat transfer from heater to load and temperature of element becomes more than the maximum element temperature and heater fails.

Answer / deepak thakur

1)if give connect more voltege than ratede voltege
2)if it heat not convert in proper place.
3)if controlling divice short ckt.
4)if its tharmocuple not fixed in proper place.

Answer / deepak thakur

1)if give connect more voltege than ratede voltege
2)if it heat not convert in proper place.
3)if controlling divice short ckt.
4)if its tharmocuple not fixed in proper place.

why middle phase should used for earth fault and other phases used for over current in overcurrent and earth fault relay?

7 Answers   ABB, ONGC,

---

ALL HT /LT PANEL TEST? DISCRIPTION.

0 Answers   Essar,

---

if our load in 3 phase circuit is 4000 amp. calculate the capacity of capacitor panel if line power factor is.80 .

1 Answers   ST Micro,

---

draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups 

0 Answers  

---

How to calculate the value of earth capacitance in a transmission line.

0 Answers  

---

have u any web site who can give all electrical sum's to solve counting easy like how to convert 1kw=?Kva.

1 Answers   Marriott,

---

explain remenance . differentiate high remenance type ct & low remenance type ct

0 Answers   Coca Cola,

---

what is the difference between Earthing,Grounding and neutral?

3 Answers   Biocon, Tata Steel Limited,

---

what is creepage distance

2 Answers  

---

what is the difference between ground, earth and neutral?????????....

1 Answers  

---

what is the meaning of x,m,k in the relays?

0 Answers   ITC Infotech,

---

at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)

0 Answers   Ebrahim Textile, Siemens,

---