Answer / k.prakashchandra

In SLD only one wire/line is to be shown.So you can show a
double contact switch and write star/delta

how capacitance is neglected in short transmission lines ?

1 Answers   BMC, Qucab,

---

if the 10 hp motor name plate indicates rated current as 13.6 amp the what will be the thermal relay setting? Why? And in how much time relay will trip at the set value?

2 Answers  

---

can we run a motor rated 50Hz,415vac,1440RPM At higher speed then rated on name plate with the help of VFD /drive on long term basis.wheater it will effect the motor life

3 Answers  

---

What are the advantages of D.O.L Starter in 3 phase induction motor?

4 Answers  

---

What will happen 50 HZ motor when you will give 60 HZ?

7 Answers   Bhushan Power Steel,

---

---

Why the motor was take the starting current is high?

3 Answers  

---

what is the voltage between earth to neutral in lift.

0 Answers   SIPL,

---

What is the formula to calculate distribution transformer De-rating on iron losses basis

0 Answers   IESCO,

---

how a DC clampmeter works if DC cant b step up r down?

1 Answers  

---

i am electrical engineer i cant get job in pure electrical industry ,but i got job in instrumentation field whether there is good scope for me, as i am fresher i m not well with the industrial trends so any experienced engineer pls reply me

2 Answers  

---

in case of OC+EF relay, how the burden is divided/calculated/shared by the CTs in case of normal (healthy condition) and during fault conditions.? three coils of OC & ef coil is conected in residual connection across the three CTS.

1 Answers  

---

In brushless excitation system how generator field current is measure even if the slip rings are absent?

3 Answers   Adani,

---