What are the three methods of the heat transfer? Give
example for each
Why air is not used to run the turbine?
When repacking a valve the rings of packing should be oriented so that the packing ends are installed ____________.
why does bitumen heated from top side bt not from bottom sideā¬
0 Answers Denso, Gammon, Punj Lloyd Ltd,
The lowest allowable insulation resistance?
a 20ph motor runnig a load with direct belts, can we use 10hp motor for the same load with the help of gear where motor rpm 900 and load rpm 250
Why do you want to work at our company
What are the causes of boiler backfire and steps in how to prevent it from happening?
What does it mean- 10mm of mercury pressure (See B.L thereje book page 1331)
What is surging in centrifugal compressor. how its happened and how to avoid it.?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
Which impurities form hard scale and which impurities soft scale ?
i just wanted to ask that what should one do to clear all the concepts a mechanical engineer needs to have cleared,this not only includes the concepts of each and every semester of his engineering course, but also the basic laws and fundamentals of physics(that required for Mechanical engineering).I am a third year mechanical engineering student and i am very keen to know about the above question. somebody please help me.