what is the procedure to start the turbine?

1 Answers   CSIR, CSIT, Hyundai,

---

How do you repair a hydraulic jack?

0 Answers  

---

Categories >> Engineering >> Mechanical Engineering Suggest New Category Question Asked @ Answers Views select what is advantage of hllow shaft over solid shaft aprt from material saving? does hollow shaft absorb more vibration than solid shaft? 0 5 wat is the meaning of cop of wet suction and dry suction????? 1 171 What is the difference between an axle and a shaft? reply soon frnds........ 4 260 16 inch = 1 ______________? 2 124 What are the steps taken in troubleshooting of a machine e.g extruder ME 0 26 What is a seal? ME 3 133 what is the mean of b.tech? 3 167 what type of pump 2 63 what is differance between ball screw and lead screw ? Amtek 1 86 What is the units of surface tension and also dimensional formula? RRB 3 218 What is meant by cigarcone? RRB 3 120 I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons 0 24 why steam power plant is more popular than gas turbine plant? ME 3 304 what is EEE in thermodynamics????? ME 2 223 what is the practical use of ENTROPY? JSW 4 282

1 Answers  

---

i am trying to select the correct grade steel for a shaft that will have a flap on it weighing about 4.5 tons being forced up with hydraulic rams. can someone tell me what grade the shaft should be and if it should be stainless steel or not

2 Answers   Rainford EMC Systems,

---

plz tell me the types of air compressors? & purpose of air drier?

3 Answers  

---

What is cutt off ratio in IC Engines.give proper defination.

5 Answers   Essar, Hyundai, Jindal Steel and Power, L&T,

---

Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75  Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in

0 Answers   Ignou,

---

what is shock in pipe line how it is happening

2 Answers  

---

what is the water condition in high pr. boiler?

2 Answers   Thermax,

---

I am completed diploma in mechanical in 2002, i have 5year experience in materials (purchase) dept,i want to do SAP cource in MM module, i want to know can i complete SAP after diploma cource only, is it usefull to me for further Job opening.

0 Answers  

---

which is heavier 1kg. of iron or 1kg. of cotton?and why?

33 Answers   Getco, Jindal, Lloyd, Naval Academy, NDA, samr, swiggy,

---

How a Diesel Engine Works in Generators?Explain with Labelled Diagram.

2 Answers  

---