Answer / hameedwahab

A: It is the actual Output of an engine (neglecting all losses) @ BHP=IHP-FHP. It is used for engineering calculations.

On what basis can sliding contact bearings be classified? Explain?

0 Answers  

---

Hiii.. i have applied for steel plant management trainee 2010 exam for stream mechanical... the pattern of the exam has changed.. a preliminary exam which consists of the engineering basics... can any one suggest any book for this... kindly respond to this...

0 Answers  

---

difference between strengh and toughness.

5 Answers   Unitech,

---

what is the purpose of wear rings in centrifugal pumps ?

5 Answers   Gulf Spic, TCS,

---

what is the peripheral velocity of two mating gears?

1 Answers   Hero Honda,

---

what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.

0 Answers   Emco,

---

In convection heat transfer, if heat flux intensity is doubled then temperature

0 Answers  

---

substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section? (a)1J, (b)75000J, (c)90000J, (d)25000J

1 Answers  

---

hra

1 Answers  

---

IS there any rake angle in blade? which is used to shave the beard ?

1 Answers  

---

What is seamless pipe

4 Answers   Armco,

---

Explain the difference between the flight of a plane and a helicopter?

0 Answers  

---