why we use condenser in the thermal power plant, althrough
the same vapour will be again heated
No Answer is Posted For this Question
Be the First to Post Answer
What are the different towers used in 132kv transmission line? what are the differences between the P,R,S towers used in 132KV and detailed explanation
why we pefer the salient pole for synchronous motor ?
Why we use 2core cable for Dc motor.Can I use 3core?
5 Answers JK Paper, Maharaja Whiteline,
What is the working of AVR in AC generators?
13 Answers Navrachana University,
What is an Isolation Xformer? What is the use of it?
why anti pumping relay is not given to tripping coil of the breaker? why only to closing coil?
Which addressing mode contains the address for data as a part of the instruction in 8085.
What is the differance between negative dc voltage and positive dc voltage because some circuit uses -24,-5,-12,- 15,volt dc supply
10 Answers eLab, Hero Honda, NTPC, Suzlon, Teradyne,
how give earthing to shif and aeroplane which is away from earth?
R u say ,that is there is any flux in your room.
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
3) How earthing is done? How it measured? Write the method for earthing? How the earth resistance is kept low?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)