Diagramming application information flow is important because:
A. it helps identify heavy traffic paths
B. it helps figure out why email gets from one place to another
C. it can tell you when to purchase a new router
D. it can tell you when to purchase a new switch
- 2 Answers
- 4599 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A
Diagramming application information flow is important
because it helps identify heavy traffic paths.
| Is This Answer Correct ? | 0 Yes | 1 No |
What are three LAPB features supported by SDLC? A. Frame types B. Frame format C. Field functions D. ABM
What should be looked at first to determine if a customer should switch from a hub environment to a switched environment? A. Investigate the number of broadcasts B. Investigate the number of collisions C. Determine what routing loops are present D. Determine which switching type is being used by the hubs
Regarding a full-mesh network and a partial-mesh network, what is the most accurate statement? A. Split Horizon will not work on a full-mesh network B. A full-mesh network is more expensive because more routers are used C. A partial-mesh network is less expensive because less virtual circuits are used D. Broadcasts are more plentiful on a partial-mesh network
When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices
What are three advantages of using fiber? A. Security B. Eliminate RFI and EMI C. Low cost D. High speed
With Centralized Routing, each node must determine and maintain its routing information independently? A. True B. False
EIGRP was developed to improve what two protocols? A. OSPF B. RIP C. BGP D. IGRP
Which router would you choose for your design? A. 1600 B. 1700 C. 3600 D. 3640 E. 7200
What is the technique used by a router that can automatically initiate and close a circuit-switched session? A. PLP B. LAPP C. ASN.1 D. DDR
What are two ways to connect a PC to a LAN when using ATM (Asynchronous Transfer Mode)? A. ATM endpoint B. ATM LAPB C. ATM router D. ATM switch
Which two of the following describe ASN.1 (Abstract Syntax Notation One)? A. It is an abstract routing protocol that is not used very often. B. It is an OSI language for describing data types independent of particular computer structures and representation techniques. C. Consists of only one basic routing algorithm. D. Uses BER (Basic Encoding Rules).
What is the standard ethernet cabling specification? (not IEEE 802.3) A. STP B. Coax (thin) C. Coax (thick) D. UTP
CCNA 
