Interested to Buy Any Domain ? << Click Here >> for more details...
What device initiates a session in an X.25 network?
A. DTE
B. DCE
C. PSE
D. PAD
- 1 Answers
- 4421 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
A DTE initiates a session in an X.25 network. The correct
order to establish a virtual circuit in an X.25 network is:
1.)The source DTE sends packet to the local DCE
2.)The local DCE packet binder sends packet to the closest
PSE (Packet Switch Exchange)
3.)The PSE (Packet Switch Exchange) passes the packet to the
next remote DCE
4.)The remote DCE examines the packet header of destination
DTE
| Is This Answer Correct ? | 2 Yes | 1 No |
What are two true statements regarding DDR (Dial-on-Demand Routing)? A. Allows a router to automatically initiate and end a circuit-switched session B. DDR cannot be configured because it is set with a default configuration C. Can configure it to be used during non-peak hours D. Can only be used with Cisco PIX
What happens to performance if the maximum MTU (Maximum Transmission Unit) size is used? A. Performance increases B. Performance decreases C. Performance stays the same D. Performance has nothing to do with the MTU
Regarding a full-mesh network and a partial-mesh network, what is the most accurate statement? A. Split Horizon will not work on a full-mesh network B. A full-mesh network is more expensive because more routers are used C. A partial-mesh network is less expensive because less virtual circuits are used D. Broadcasts are more plentiful on a partial-mesh network
What set of Frame Relay enhancements offer extensions for managing complex internetworks? A. CMT B. SNMP C. LMI D. RMON
What are two differences between 10BaseT and 100BaseT? A. Speed B. Frame format C. Addressing D. Network diameter
EIGRP was developed to improve what two protocols? A. OSPF B. RIP C. BGP D. IGRP
What is the first step in diagramming packet flow for the terminals within a network? A. Identify the end user nodes of all the terminals B. Figure out the speed of all the servers C. Find out where all the routers are located D. Find out where all the switched are located
What are three ASN.1 (Abstract Syntax Notation One) data types? A. data feeds B. name C. syntax D. encoding
What are two services that the OSPF Hello protocol provides? A. It discovers neighbor routers B. It gets routes from neighbors during startup C. It helps elect a designated router D. It allows administrator to test for connectivity between two devices
What would you include in your prototype design for this particular case study?
How can change k-value in EIGRP configuration.
When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information
CCNA 
