Interested to Buy Any Domain ? << Click Here >> for more details...
SNMP agents are:
A. Management devices
B. NMS (Network Management Stations)
C. network devices such as routers, switches, or hubs
D. PDUs
- 1 Answers
- 8584 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: C
SNMP agents are network devices such as routers, switches,
or hubs. An NMS acts as the manager and communicates with
the agents for information about their performance.
| Is This Answer Correct ? | 33 Yes | 4 No |
Which condition does not create LAN media problems? A. Protocol doesn?t scale well B. Long wait for the token C. Excessive collisions D. Too many devices
Match the following services with the correct descriptions: A. BRI 1. Provides two 64 Kbps B channels B. PRI 2. Provides 23 or 30 B channels 3. Provides one 16 Kbps D channel 4. Provides one 64 Kbps D channel 5. Provides a total bit rate of 2.048 Mbps in Europe and Australia 6. Provides a total bit rate of 144 Kbps 7. Provides a total bit rate of 1.544 Kbps in North America and Japan
Distance Vector and Link-State protocols converge more quickly if: A. there is router redundancy B. there is router redistribution C. the update interval is set to its maximum D. the whole routing table is sent to announce changes
What is the second step when creating a prototype? A. Develop a test plan B. Review the customer requirements C. Investigate what the competition will be proposing D. Define how big the prototype will be
What are the four basic components of an AppleTalk network? A. Sockets B. Nodes C. Networks D. Areas E. Zones
What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay
how many default route can be configure on a router
When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information
What is the first step in diagramming packet flow for the terminals within a network? A. Identify the end user nodes of all the terminals B. Figure out the speed of all the servers C. Find out where all the routers are located D. Find out where all the switched are located
6. Which of these statements best describes VPLS ?
What would a TE2 device be used for in an ISDN connection? A. as a connection from an NT1 device to an NT2 device B. as a connection from a non-ISDN terminal through a TA to the ISDN network C. as a connection from four-wire subscriber wiring to the conventional two-wire local loop D. as a connection to the ISDN network through a four-wire, twisted-pair digital link
Which address is updated at each hop in the path in path switching?
CCNA 
