What are two services that DUAL (Diffusing Update Algorithm)
performs for EIGRP?
A. Provides loop-free operation throughout an entire route?s
computation
B. Simultaneous synchronization of routers involved in a
topology change
C. Updates the autonomous system number
D. Allows advertised distances to use feasible distances
- 1 Answers
- 3690 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A and B
Two services that DUAL (Diffusing Update Algorithm) performs
for EIGRP are providing loop-free operation throughout an
entire route?s computation and simultaneous synchronization
of routers involved in a topology change.
| Is This Answer Correct ? | 1 Yes | 0 No |
Match the following routing protocols with their routing algorithm. A. OSPF 1. Distance Vector B. IGRP 2. Link-State C. RIP D. IS-IS E. NLSP F. RTMP G. AURP H. BGP
The following are the four steps in establishing an X.25 virtual circuit. Place them in the correct order. A. The PSE (Packet Switch Exchange) passes the packet to the next remote DCE B. The local DCE packet binder sends packet to the closest PSE (Packet Switch Exchange) C. The source DTE sends packet to the local DCE D. The remote DCE examines the packet header of destination DTE
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
5. Which Two Settings must be configured in order to use the GUI to configure Call Admission Control with voice Applications
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
6. Which of these statements best describes VPLS ?
When characterizing a network, how many buffer misses should not be exceeded on a Cisco router per hour? A. 10 B. 25 C. 50 D. 100
What are two services that DUAL (Diffusing Update Algorithm) performs for EIGRP? A. Provides loop-free operation throughout an entire route?s computation B. Simultaneous synchronization of routers involved in a topology change C. Updates the autonomous system number D. Allows advertised distances to use feasible distances
What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay
When designing a flat switched network you can have: A. the same number of IP and IPX nodes without performance degradation B. more IP than IPX nodes on the same segment C. more IPX than IP nodes on the same segment D. more AppleTalk than IP nodes on the same segment
In an ATM network, which type of device is in a LAN per ELAN (Emulated LAN)? A. LAN Emulation Workstation B. LAN Emulation Router C. LAN Emulation Server D. LAN Emulation Bridge
CCNA 
