Which condition does not create LAN media problems?
A. Protocol doesn?t scale well
B. Long wait for the token
C. Excessive collisions
D. Too many devices
Answer / guest
Answer: A
Using Cisco?s Small-to-Medium-Sized Business Solutions
Framework, most customer problems fall into one of three
categories: Media Problems, Protocol Problems, and Transport
Problems. The answer ?Protocol doesn?t scale well? would
fall into the ?Protocol Problems? category.
| Is This Answer Correct ? | 0 Yes | 0 No |
When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information
What AppleTalk protocol permits AppleTalk workstations to share files across a network?
Match the following routing techniques with the correct descriptions: A. Static Routing 1. Mandatory configuration B. Dynamic Routing 2. No route updates 3. Can better tolerate failures 4. Sends update when topology changes 5. Path is determined by the router 7. Traffic is reduced
Which of the following three protocols replace SDLC? A. 802.2 B. HDLC C. QLLC D. X.25
What should be looked at first to determine if a customer should switch from a hub environment to a switched environment? A. Investigate the number of broadcasts B. Investigate the number of collisions C. Determine what routing loops are present D. Determine which switching type is being used by the hubs
How can change k-value in EIGRP configuration.
What would a TE2 device be used for in an ISDN connection? A. as a connection from an NT1 device to an NT2 device B. as a connection from a non-ISDN terminal through a TA to the ISDN network C. as a connection from four-wire subscriber wiring to the conventional two-wire local loop D. as a connection to the ISDN network through a four-wire, twisted-pair digital link
When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices
Which IP address is not a private address? A. 142.18.0.0 B. 10.0.0.0 C. 172.16.0.0 D. 192.168.0.0
What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer
how many switches can be cascaded
What are three ASN.1 (Abstract Syntax Notation One) data types? A. data feeds B. name C. syntax D. encoding