Answer / guest

Answer: B and D

The routing metrics used with IGRP are load, delay,
reliability, and bandwidth.

Match the following services with the correct descriptions: A. BRI 1. Provides two 64 Kbps B channels B. PRI 2. Provides 23 or 30 B channels 3. Provides one 16 Kbps D channel 4. Provides one 64 Kbps D channel 5. Provides a total bit rate of 2.048 Mbps in Europe and Australia 6. Provides a total bit rate of 144 Kbps 7. Provides a total bit rate of 1.544 Kbps in North America and Japan

1 Answers  

---

What are two services that DUAL (Diffusing Update Algorithm) performs for EIGRP? A. Provides loop-free operation throughout an entire route?s computation B. Simultaneous synchronization of routers involved in a topology change C. Updates the autonomous system number D. Allows advertised distances to use feasible distances

1 Answers  

---

Traffic Shaping does which one of the following? A. Eliminates bottlenecks by throttling back traffic volume at the source or outbound end B. Reduces the frame size so bandwidth is better utilized C. It increases source traffic to a configured bit rate D. Allows you to control hubs and repeaters

1 Answers  

---

Client traffic is being bridged trough LAN interfaces on two WLCs.Which roaming option will Keep them on the same IP Subnet ?

2 Answers   Pari Networks,

---

When should you apply SAP filters to Netware service advertisement messages? A. When services are not required for a particular area or network B. Only after service advertisement messages have flooded the network C. Before any type of router convergence takes place D. When no change in network services has taken place for 40 minutes

1 Answers  

---

What is the first step in diagramming packet flow for the terminals within a network? A. Identify the end user nodes of all the terminals B. Figure out the speed of all the servers C. Find out where all the routers are located D. Find out where all the switched are located

3 Answers  

---

When is the route to a node determined in an SRB (Source Route Bridging) Token Ring network? A. Before any data is transmitted B. After the data is transmitted C. During the transmission of data D. After the first frame is transmitted

1 Answers  

---

How is data transmitted in a Token Ring network? A. The node calls for a token, appends the data, modifies a bit in the frame, then sends the token B. The node waits for the token, gains possession of it, appends the data, modifies a bit in the frame, then sends the token C. The node transmits the data whenever it wants to D. The active monitor must first grant permission for the node to transmit data. After it receives permission, it sends the data

1 Answers  

---

You may receive a case study including Token Ring and Ethernet, so you may want to look at any constraints with cabling between Token Ring and Ethernet networks. Which statement describes the constraints imposed by the existing network? A. Replace all cabling B. Test all cabling C. Do not replace cabling D. Use microwave instead of cabling

1 Answers  

---

Which Of the Statements best describes VPLS ?

1 Answers   Pari Networks,

---

how many switches can be cascaded

2 Answers  

---

Which address is updated at each hop in the path in path switching?

1 Answers  

---