What task do you complete to identify organizational
objectives that will reflect your design?
A. Business Objectives
B. Scheduling requirements
C. Vacation time
D. Meetings
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A
You need to look at the business objectives of your customer
so that you?re able to identify organizational objectives.
These can have a big impact on how you design the network.
| Is This Answer Correct ? | 1 Yes | 0 No |
How can change k-value in EIGRP configuration.
Which Of the Statements best describes VPLS ?
SNMP agents are: A. Management devices B. NMS (Network Management Stations) C. network devices such as routers, switches, or hubs D. PDUs
With Centralized Routing, each node must determine and maintain its routing information independently? A. True B. False
What happens to performance if the maximum MTU (Maximum Transmission Unit) size is used? A. Performance increases B. Performance decreases C. Performance stays the same D. Performance has nothing to do with the MTU
What type of address is analyzed by a Layer 2 switch? A. network address B. MAC and network address C. Protocol type, MAC, and network address D. MAC address
What would a TE2 device be used for in an ISDN connection? A. as a connection from an NT1 device to an NT2 device B. as a connection from a non-ISDN terminal through a TA to the ISDN network C. as a connection from four-wire subscriber wiring to the conventional two-wire local loop D. as a connection to the ISDN network through a four-wire, twisted-pair digital link
Our company order a cisco ws-c3750x-48t-s(here i bought from http://www.3anetwork.com/cisco-ws-c3750x-48t-s-price_p104.html), As for the switch, in addition to the port module and optical module can be extended, what else module can also be extended?
When should you apply SAP filters to Netware service advertisement messages? A. When services are not required for a particular area or network B. Only after service advertisement messages have flooded the network C. Before any type of router convergence takes place D. When no change in network services has taken place for 40 minutes
Which of the following is not true in regards to route summarization? A. It increases the size of the routing table B. It increases the complexity of the network C. IP networks must be contiguous to be safely summarized D. Routing tables must have the capacity to support classless routing
When is the route to a node determined in an SRB (Source Route Bridging) Token Ring network? A. Before any data is transmitted B. After the data is transmitted C. During the transmission of data D. After the first frame is transmitted
Which of the following three protocols replace SDLC? A. 802.2 B. HDLC C. QLLC D. X.25