Hi If connecting a temp generator 670KVA .415kv with step up Tx .415/11kv. I

Hi
If connecting a temp generator 670KVA .415kv with step up
Tx .415/11kv.
I am given Generator impedances Z1 Z2 Z0 to 100MVA base. Do
I need to work out the generator fault current by using
these impedances i.e gen rating / impedance. Then use this
as my source impedance for the calculations that follow.

Question Posted / kenster301

0 Answers
2034 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

10 hp motor ,7.5 kw ,960 rpm, full load current 15.5, delta connection so how much take current no load trial time. any formula please give..... second question :- what is different between brekar control wiring and motor starter control wiring

1 Answers MSP,

PID controller details

1 Answers

seromechanism

4 Answers Bhel,

There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2

0 Answers

how are reversing the direction of rotation of dc motor

0 Answers

What is difference between miniture circuit breaker and module case circuit breaker up to 63Amp.

7 Answers MSPL,

Why can't we parallel Voltage transformer secondary circuits?

0 Answers

Wheather there exist any dc transformer

6 Answers

what is meant by power and distribution transformer ?

0 Answers CG,

how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???

0 Answers

what is EIB lighting control system? what is the advantages of this system?

0 Answers

In power transformer tappings are provided on A high voltage side B low voltage side C In middle of both the windings D both high and low voltage side

2 Answers NNN,

For more Electrical Engineering Interview Questions Click Here