Answer / mohsin moulvi

Water Hammering in case of turbines may be explainedas:
Turbines are operated at four levels 1.) 1/4 throttle 2).
1/2 throttle 3.) 3/4 throttle 4.) full throttle.
when the valve opening opening in the turbine is suddenly
closed the water coming in from the penstock makes an
impact on the shutter which is closing the gateway. as a
result of this a back pressure is set up in the pipeline.
The phenomenon of water impacting on the valve shutte in
known as Water hammer.
All suggesstions welcome I am not sure about steam but
common sense says that in steam pipeline the phenomenon be
the same only that fluid be replaced with steam

Answer / devanesan

in the water flow air will cause for hammering because of
dencity difference of liquid and air. both will have
different velocity the water hit the pipe wall and
hammering is happening. in the steam line also the same
phenomina happening. and one more is if the pipe line is
cool then the steam contrased when come contact with cool
pipe. it also cause for hammering.
there should not be any different dencity fluid while flow.

Answer / salai jeyaveeran

when a hot steam is passed in a pipe containing a
condensate water particle due to sudden variation in
temperature the particle starts to expand vigarously causes
a sound heard like hammering

The advantage of a controllable pitch propeller?

1 Answers  

---

Types of bearing and types of gears?

4 Answers  

---

What does a pump develops? Flow or Pressure. Give the Answer with Proper Logic.

3 Answers   DVC,

---

i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.

0 Answers  

---

two shafts should have same strength? a)dia b)same material c)angle of twist d)twisting moment

2 Answers   Keihin Fie,

---

Causes of emergency trip of diesel engine

1 Answers   RRB,

---

Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com

0 Answers  

---

Bearing no : 6402 what is the ID ,OD,width

0 Answers   ABC, SRACO,

---

Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.

0 Answers  

---

What is the use of a PULLEY?

12 Answers   Essar, L&T, Valeo Lighting Systems India Private Limited, Wipro,

---

Explain what is torque?

0 Answers  

---

capacity of concrete mixer

1 Answers  

---