Interested to Buy Any Domain ? << Click Here >> for more details...
What is hammering in steam or water flow pipe line. how it
is happening.
- 3 Answers
- 5807 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohsin moulvi
Water Hammering in case of turbines may be explainedas:
Turbines are operated at four levels 1.) 1/4 throttle 2).
1/2 throttle 3.) 3/4 throttle 4.) full throttle.
when the valve opening opening in the turbine is suddenly
closed the water coming in from the penstock makes an
impact on the shutter which is closing the gateway. as a
result of this a back pressure is set up in the pipeline.
The phenomenon of water impacting on the valve shutte in
known as Water hammer.
All suggesstions welcome I am not sure about steam but
common sense says that in steam pipeline the phenomenon be
the same only that fluid be replaced with steam
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
What is the most economical spacing of buttress ?
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
What is the different between brass and bronze ?
Why is thick steel wire stronger than thin steel wire?
What is the maximum P-max for a cylinder in M/E.
Preparation before arriving port?
What will happen if you blow the soot in the boiler?
how do you close arc into circle in catia
As per api 650 code for new ss tank fabrication,in bottom plate bulge is acceptable? How many bulge acceptable for api 650?
explain the omportance of "squish" and "swirl" in ci engine
What type of cross-section is usually of a chisel?
Why do you need a biological shield in nuclear plants?
If the black box flight recorder is never damaged during a plane crash, why not the whole airplane made out of that stuff?
Dear sir, I have applied section engineer post at rrb Chennai.Please send me the previous technical question papers and answers
How do you detect starting valve leaks?
